I got it

Me and my uncle (tgragg) mounted my battery charger today. Here is what we did.
We got two aluminum strips from the good ole Home Depot that was 36 in. long 2in. wide and 1/8in. thick. Cut one piece in half, 18". And cut the other piece at 15 in. What the strips are going to go is on the step pad (on the floor where the batteries sit), and on the bottom of the splash weld, at about a 30 degree angle. We bended the strips on the top and bottom approximatley about an inch on top and about 2 inches on bottom. Both were bent back towards the transom, the 18 in pieces. So that the top and bottom of the strips would be parallel to the splash weld and the floor. Then we drilled two holes on the splash weld to support the top of the strips. The bottom we used some epoxi, since all of the weight would be on top of the strips since it is at the angle. Then the second strips, 15 in., we bolted them to the 18 in pieces for more support.
then mounted the charger to it and it looks sweet.
I will post pics real soon and you can get a little bit more of an idea what was done. :rock_on::dancing_banana::Rolling:

 

This post is hidden to guests.
To view this post, please log in.
If you are not a member, you will need to sign up.

 

This post is hidden to guests.
To view this post, please log in.
If you are not a member, you will need to sign up.

 

This post is hidden to guests.
To view this post, please log in.
If you are not a member, you will need to sign up.

 

This post is hidden to guests.
To view this post, please log in.
If you are not a member, you will need to sign up.

 

This post is hidden to guests.
To view this post, please log in.
If you are not a member, you will need to sign up.

 

This post is hidden to guests.
To view this post, please log in.
If you are not a member, you will need to sign up.